Lorex Technology DXR43000 Series Manuel d'utilisateur télécharger pdf (Page 10)

4 GETTING STARTED

1. Connect the AC Power Cord to the Power Adapter and plug it into an

electrical outlet.

2. Connect up to 4 cameras to the BNC video inputs on the back of the DVR.

3. Plug in the power adapter to the back panel. The Red LED indicator will

illuminate and the DVR will be in the standby mode

4. The following messages appear when the power is ON successfully.

Note: The system is only checking for a MASTER HDD. Install the Slave HDD onto the

DVR (if using a Slave HDD), set up the Slave HDD in the MAIN MENU CONTROL

settings and restart the DVR.

Note: If the HDD is not properly connected a FAIL message appears. Try reconnecting

the HDD and turn on the power.

*** MASTER HDD DETECT ***

POWER ON CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ OK

HDD IDENTIFY CHECK _ _ _ _ _ _ _ _ _ __ _ _ _ OK

HDD R/W CHECK _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ __ OK

MODEL :XXXXXXXXXXXXXXXXXXXXXX

HDD LBA : XXXXXXXXXXXXXXXXXXXXXX

HDD SPACE : XXX GB

100 %

Dynamic IP Request OK

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 60 61

Pas de commentaire

Lorex Technology DXR43000 Series Manuel d'utilisateur Page 10